HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a ST1000DM003-1CH162 with firmware CC46.
The average temperature for this hard disk model is 32°C (min=24°C max=41°C) and yours is 34°C.

		Attribute		Current		Raw
		Raw Read Error Rate		118		00000B850378
		Spin Up Time		97		000000000000
		Start/Stop Count		100		00000000015C
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		75		0000020B68D0
		Power On Hours Count		100		000000000352
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		00000000015A
		SATA Downshift Error Count		100		000000000000
		End To End Error Count		100		000000000000
		Reported Uncorrectable Errors		100		000000000000
		Command Time Out		100		000000000000
		High Fly Writes		99		000000000001
		GSense Error Rate		100		000000000000
		Power Off Retract Count		100		00000000000A
		Load Cycle Count		99		0000000008A0
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write head		100		839E00000351
		Total LBAs Written		100		000143B413AE
		Total LBAs Read		100		000227F7F1B7