HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a ST9750423AS with firmware 0001SDM1.
The average temperature for this hard disk model is 36°C (min=25°C max=47°C) and yours is 44°C.

		Attribute		Current		Raw
		Raw Read Error Rate		119		00000C55A0D8
		Spin Up Time		99		000000000000
		Start/Stop Count		37		00000000FFFF
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		81		000007461BF9
		Power On Hours Count		94		000000001602
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		0000000003B4
		End To End Error Count		100		000000000000
		Reported Uncorrectable Errors		60		000000000028
		Command Time Out		100		00000005000B
		High Fly Writes		100		000000000000
		GSense Error Rate		100		00000000008E
		Power Off Retract Count		100		00000000000D
		Load Cycle Count		85		0000000079B4
		Hardware ECC Recovered		119		00000C55A0D8
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write head		100		C680000015B2
		Total LBAs Written		100		00005BD9B071
		Total LBAs Read		100		0000D554DC6C
		Free fall protection		100		000000000000