HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a FUJITSU MHV2060AH with firmware 000000A0.
NOTE: a S.M.A.R.T. model for this hard disk is not available (yet). Attribute comparison has been made against standard values. New models are computed often and in the future this hard disk should take advantage of the additional crowd knowledge.

Your hard disk temperature is 47°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000027B32
		Throughput Performance		100		000000F10000
		Spin Up Time		100		000000000001
		Start/Stop Count		100		000000000048
		Reallocated Sector Count		100		07D000000000
		Seek Error Rate		100		000000000F64
		Seek Time Performance		100		000000000000
		Power On Hours Count		100		0000000E5D30
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		000000000048
		Power Off Retract Count		100		000000000009
		Load Cycle Count		100		0000000000B2
		Hardware ECC Recovered		100		0000000018EB
		Reallocated Event Count		100		00001B280000
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write Error Rate		100		00000000605D
		Run Out Cancel		100		0164019A0063