HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a MAXTOR STM3250820A with firmware 3.AAE.
The average temperature for this hard disk model is 38°C (min=28°C max=48°C) and yours is 35°C.

		Attribute		Current		Raw
		Raw Read Error Rate		110		000005A80C6F
		Spin Up Time		96		000000000000
		Start/Stop Count		97		000000000C75
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		82		00000B0FED8A
		Power On Hours Count		91		000000002036
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		00000000035E
		Reported Uncorrectable Errors		100		000000000000
		High Fly Writes		100		000000000000
		Hardware ECC Recovered		62		00000BB34360
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		0000000000C7
		Write Error Rate		100		000000000000
		TA Increase Count		100		000000000000