HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a SAMSUNG MP0603H with firmware UD100-14.
The average temperature for this hard disk model is 42°C (min=28°C max=54°C) and yours is 51°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000006
		Spin Up Time		100		000000000C00
		Start/Stop Count		99		0000000005B3
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		100		000000000000
		Seek Time Performance		100		000000000000
		Power On Hours Count		99		00000009A261
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		0000000002DA
		GSense Error Rate		86		00000002461D
		Hardware ECC Recovered		100		00000033A9BD
		Reallocated Event Count		36		00000000008C
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write Error Rate		100		000000000000
		Soft Read Error Rate		100		000000000000
		Load Retry Count		100		000000000000
		Load Cycle Count		96		00000000B2FB
		Unknown attribute 255		100		000000000003