Hard disk health and reliability analysis

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a ST3160811AS with firmware 3.AAE.
The average temperature for this hard disk model is 37°C (min=28°C max=46°C) and yours is 30°C.

  Attribute   Current   Raw
Raw Read Error Rate 117 000009108108
Spin Up Time 95 000000000000
Start/Stop Count 100 000000000096
Reallocated Sector Count 100 000000000000
Seek Error Rate 60 000B00ABBBBD
Power On Hours Count 99 000000000516
Spin Retry Count 100 000000000000
Power Cycle Count 100 0000000000B9
Reported Uncorrectable Errors 100 000000000000
High Fly Writes 100 000000000000
Hardware ECC Recovered 57 000000E9C0E5
Current Pending Sector 1 0000FFFFFFFF
Offline Uncorrectable Sector Count 1 0000FFFFFFFF
Ultra DMA CRC Error Rate 200 000000000001
Write Error Rate 100 000000000000
TA Increase Count 100 000000000000

All the attributes of your hard disk are above the S.M.A.R.T. thresholds set by the manufacturer. This is good.

BLOCKING ISSUE : your hard disk has 65535 pending sectors (this value is very large and your hard disk should be replaced). Those are sectors that couldn't be properly read and that the hard disk logic is waiting for a write operation to try to remap to a spare sector (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.

BLOCKING ISSUE : your hard disk has 65535 offline uncorrectable sectors (this value is very large and your hard disk should be replaced). Those are sectors that an offline scanning found as unreadable. Offline scanning is a process that can be automatically started by the hard disk logic when a long enough idle period is detected or that can be forced by some tool. Those unreadable sectors are identified and the hard disk logic is waiting for a write command that will overwrite them to try to remap them to spare sectors (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.

The overall fitness for this drive is 0%.
The overall performance for this drive is 90%.

The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.


DISCLAIMER: this report does its best to highlight issues and warnings related to your hard disk. It cannot be held responsible for any mistake. This page and its results cannot be used in any other way but the one defined by its author.