HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a WDC WD20SMRW-59YNDS0 with firmware 01.01A01.
NOTE: a S.M.A.R.T. model for this hard disk is not available (yet). Attribute comparison has been made against standard values. New models are computed often and in the future this hard disk should take advantage of the additional crowd knowledge.

Your hard disk temperature is 34°C.

		Attribute		Current		Raw
		Raw Read Error Rate		200		000000000000
		Spin Up Time		196		000000000C56
		Start/Stop Count		93		000000001F24
		Reallocated Sector Count		200		000000000000
		Seek Error Rate		200		000000000000
		Power On Hours Count		90		000000001D9B
		Spin Retry Count		100		000000000000
		Calibration Retry Count		100		000000000000
		Power Cycle Count		100		000000000040
		Power Off Retract Count		200		000000000009
		Load Cycle Count		142		00000002B1A1
		Reallocated Event Count		200		000000000000
		Current Pending Sector		200		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write Error Rate		100		000000000000