Hard disk health and reliability analysis

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a KINGSTON SUV400S37240G with firmware 0C3J96R9.
The average temperature for this hard disk model is 32°C (min=24°C max=43°C) and yours is 33°C.

  Attribute   Current   Raw
Raw Read Error Rate 100 000000000000
Reallocated Sector Count 100 000000000000
Power On Hours Count 100 00000000011A
Power Cycle Count 100 000000000016
Unknown attribute 100 100 0000000215E0
Unknown attribute 101 100 000000008EA0
Unknown attribute 170 100 000000000000
Unknown attribute 171 100 000000000000
Unknown attribute 172 100 000000000000
Unknown attribute 174 100 00000000000D
Unknown attribute 175 100 000000000000
Unknown attribute 176 100 000000000000
Unknown attribute 177 100 000000000028
Unknown attribute 178 100 000000000000
Unknown attribute 180 100 00000000057E
SATA Downshift Error Count 100 000000000000
Reported Uncorrectable Errors 100 000000000000
Hardware ECC Recovered 100 000000000000
Reallocated Event Count 100 000000000000
Current Pending Sector 100 000000000000
Ultra DMA CRC Error Rate 100 000000000000
Soft Read Error Rate 100 000000000000
Shock Count Write Opern 100 000000000000
Unknown attribute 233 100 0000000000E6
Unknown attribute 234 100 0000000000D2
Total LBAs Written 100 0000000000DB
Total LBAs Read 100 00000000000B
Read Error Retry Rate 100 000000000000

All the attributes of your hard disk are above the S.M.A.R.T. thresholds set by the manufacturer. This is good.

The overall fitness for this drive is 100%.
The overall performance for this drive is 100%.

The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.


DISCLAIMER: this report does its best to highlight issues and warnings related to your hard disk. It cannot be held responsible for any mistake. This page and its results cannot be used in any other way but the one defined by its author.